Thiết kế gân Thiết kế gân sao cho b

Ribbed design Ribbed design to product thickness as thin as possible. If property requires firmware higher hardness gap the tendons as fall short again. Tendon geometry shape increase durability: thickness, altitude, angle of taper are related with each other, if the tendon thickness is too large can result in sunken place opposite the tendons and if too big taper angle makes the top tendon was too small to cause difficulties for the process to complete. The tilt of the tendon of each side about 10, if the stereotypes are polishing, the tilt of the tendons can be 0.5°. Ribbed bottom thickness allowed by 0.8 times the thickness of products at home to tendons. Usually, the bottom thickness tendon from 0.5-0.8 times the thickness of products in where the tendons. Location of tendons to increase durability, convex lobes (bosses) and the gussets: tendons to increase durability must be straight direction with open molds.

Nearby Design
Nearby Design products so that thickness as thin as possible. If the
product requires higher stiffness gap increasingly shortened tendons.
The geometry increases tendon strength: thickness, elevation, taper angles are related to each other, if the thickness is too large can tendon leading to dent spot opposite the tendon and if too large taper angle near the top is too small to make it difficult for the filling.
the inclination of the ribs on each side about 10, if the mold is polished, the inclination of Nearby can be 0.5 °. Bottom largest tendon thickness by 0.8 times allowing the product thickness at where tendons. Typically, the thickness of the bottom tendon thickness from 0.5-0.8 times the product at the place where the tendon.
The position of increased strength tendons, convex lugs (bosses) and gussets: increased tendon strength must lie straight towards the molding direction.