A basic slide system components include the following:
- Fasteners oblique: function used to move the sliding blocks effect. The angle
of tilt latches with vertical skewer usually about 5 → 28 °. The magnitude
of the angle and length of the journey key decisions of the core sliding side panels.
- Sliding Core: is part of the detailed shaping molds, often sliding
on wear resistant plate is kept in the system and guide rails.
- ray instructions: keep sliding core, ensure the core sliding motion
determination and gently without any deviation from that.
- Sheets anticorrosive: creating core surface for sliding movement, wear
and tear over the life of the molds.
Plates push
the latch mold oblique
details
Core
the
slide
(a)
mold closed
mold the
(c)
step detail
the mold
(b)
mold open, drag the slider
along the bottom horizontal skewers
the mold
140
- structure hold : keep sliding core molds at fully open.
- Block wedges: sliding lock stationary core during injection. Wedge under
pressure the whole, do not touch the core latch oblique sliding throughout this process.
đang được dịch, vui lòng đợi..