Bước 2: Lắp steeel ring (3) vào op

Bước 2: Lắp steeel ring (3) vào optical holder (1) để giữ chặt tấm kính. Chú ý khi vặn chặt steel ring phải giữ cố định kính để chấm trắng trùng với vạch LM1-A và đảm bảo kính polarizer không bị xoay theo trong quá trình siết chặt.

Kết quả (Anh) 1:

Step 2: insert the steeel ring (3) on optical holder (1) to hold the glass panels. Note When tighten the steel ring to hold the glass fixed to the white dots coincides with planned LM1-A and make sure the glass polarizer is not rotated as during clenching.

Kết quả (Anh) 2:

Step 2: Insert steeel ring (3) into the optical holder (1) to hold the glass. Note to tighten the steel ring fixed to the glass to keep the white dot LM1-A coincide with bar and glass ensure Polarizer not rotate during tightening.

Kết quả (Anh) 3:

Second step: installed in the optical steeel ring (3) champion (1) holding the glass. Note that when adjusting the steel ring to maintain a fixed glass point matching LM1 sub white line, to ensure that the glass is not polarizer in the rotation process of the extrusion.