-About the push must be greater than 5 ÷ 10 mm from a height of producttaken from the mold after the direction split the mold. Should not do aboutpush too long, too small sometimes about long push will weaken the systempropulsion system. Size of the push pin depends on the size of the product,the diameter must be greater than 3 mm, unless that is necessary for the product.-After the product is removed, push the system to return to the location of the BoardFirst, avoid damage please push the latch mold. Thus the need to handle feedback about (company feedback).The latch and latch push push plate is located on the same plate, push the large pressure shouldpush plates must also have appropriate thickness:-The system design pushes the stars to not weaken the mold.-The products with long or push the cruise pegs pushedsmall, then there should be the Guide pin in the system pushes
đang được dịch, vui lòng đợi..