* Snowman this page after South Korea: + Detailed structure, clusters must be straightening, flat according to the design requirements, make sure satisfy the size of product Assembly. + The Sharpener Eraser temporarily engaged in the process of grinding blunt, fastening the edge. .. ensure aesthetics of the product.e. the product control numbers.-Number of products will be based on the basis of the name or symbol of the details or detailed phrases.-The number is two-fold:-Numbered before painting: the number was close to sink directly on the product, on the main projectionof the product and ensure after installation (not close to the surface of the Assembly). The small details, the details are thin that when played will cause distortion, the number will be built on a 2-3 mm thick corrugated sheets, size 120x100mm, then South Korea attached to the product or use the soft steel wire ị2-ị3 mm hanging on the product. The numbering must follow a certain sequence to recognizable in the painting process, shipping and installation.-Numbered after the son: the more components after the paint was written by identification numberthe paint does not delete the other jerseys have been with paint colors of the product. At the same time must adhere to that numbering process; or write more information about specifications, structure or a mass of details.
đang được dịch, vui lòng đợi..